The Gastronomic Regenerator: A Simplified and Entirely New System of Cookery: With Nearly Two Thousand Practical Receipts Suited to the Income of All Classes

obtain, quite fat, and not at all red, or it would break and cause a deal of trouble. To cut it, take off the piece of lean at the bottom, lay it upon a board with the rind upwards, and beat gently with a cutlet-bat, trim the sides, and cut it into bands the breadth that you may require your lardons in length; if for a fillet of beef, two inches; for fricandeau, turkey, poularde, fowl, pheasant, or sweetbread, an inch and a half; and for lamb’s sweatbreads much smaller. Take one of the bands, place it before you with the rind downwards, and with a sharp knife cut it in slices, (but not separating it from the rind), of the thickness you require for the article you are about to lard, then place your hand at the top, press lightly, and draw your knife straight along as if cutting the bacon in slices, so as to form the lardons square at each end, commencing cutting from the heel of the knife, and finishing at the point. To lard, the French method is so familiar to me that I cannot but recommend it, especially to inexperienced hands. If a fricandeau, lay it lengthwise upon a clean napkin across your hand, forming a kind of bridge with your thumb at the part you are about to commence at, having previously taken all the skin from the veal with a knife, then with the point of your larding-needle make three distinct lines across, half an inch apart, run your needle into the third line (at the further side of the fricandeau), and bring it out at the first, placing one of the lardons in it, draw the needle through, leaving out a quarter of an inch of the end of the bacon at each line: proceed thus to the end of the row; then make another line half an inch distant, stick in another row of lardons, bringing them out at the second line, leaving the ends of the bacon out all of the same length; make the next row again at